Stamp Settings
Configure stamp thickness, fit, relief depth, curves, and traced edges.
Stamp settings appear for Stamp, Cutter + Stamp, Texture Roller, Cake Pop Mold, and Sandwich Cutter when Generate Stamp is enabled.
Back thickness
Back thickness controls the solid plate behind the stamp face. The default is 5.5 mm, leaving a solid layer above a threaded grip socket while preserving full thread engagement. Texture Rollers do not show this control.
Stamp clearance
Stamp clearance / tolerance creates space between a Stamp and its matching cutter. It appears for Stamp and Cutter + Stamp. The default is 0.9 mm.
Printer, filament or resin, layer height, and orientation affect the actual fit. Test a small design before relying on a new tolerance.
A standalone Stamp uses the full requested size. Clearance reduces the stamp only when it is generated as part of a Cutter + Stamp set.
Imprint depth
Imprint depth controls the height of the raised or recessed stamp face. The default is 3 mm. For Texture Rollers it controls the raised or engraved pattern depth.
Depth curve
Stamp, Cutter + Stamp, Texture Roller, and Cake Pop Mold can use Flat, Dome, Round, or Chamfer depth profiles. Non-flat curves expose direction and target controls; Dome and Chamfer also use Curve inset. Curves require Premium.
Invert
Invert swaps the regions that emboss and deboss. It is available for stamp-producing types, requires Premium, and is disabled while a non-flat depth curve is active. Texture Rollers use Invert pattern instead.
Delete outer edge
Delete outer edge removes a supported outside traced boundary from the stamp face or roller pattern. It is available only when the design contains nested shapes inside a single complete outline and requires Premium.
For Stamp and Cutter + Stamp, the default Preserve outline method keeps the original silhouette while retaining more interior detail. Those types can select the earlier Offset inward behavior under Experimental settings. Texture Rollers do not show the method selector.